Ron, Thanks for your great mailing. You've raised some excellent points. >Will IR tell me that the average/desirable Sabin value from 20Hz to 4KHz for a .3 reverberation time in a 17X14X7 room is 148.6? >A fundamental problem I see with IR is that the accoustical values of good rooms are being applied to signals that are created in very poor accoustical environments where frequency responses in the audible range are not flat. In this scenario, only half the problem is being addressed. This might not be a problem with IR as much as it is a mis- use or underutilization issue. You are absolutely right on both points. This is why I emphasized earlier that the application of the impulse response function is the "trivial" part of the problem. The larger problem is to design either a real room or a virtual room for the sound. It's also why I asked about instrument generation. Physical modelling of both the instruments and the room is one way to provide the non-acoustical sources Steve mentioned in an idealized environment. [*] It's more of a misuse and underutilization issue, IMO, as I'll discuss later in this mailing. >My point is that great room modeling, reverberation and echo tools are "the cart before the horse." In some cases, that's correct; in others it's not correct. Many of us have sampler synths or sample CD's or purely synthesized tones (and I have my instrument generator). Many of these samples are fine for putting into a room modelling program. But --- I certainly do agree wholeheartedly that discussing IR's is premature if one isn't thinking along the lines you've mentioned in your mailing. IR's are way down the line, practically the last step as they are actually applied. But the considerations that lead to them are present throughout the recording and mixing process. >Almost everyone on this list has a recording studio in an untuned room. [Snip] So, what good does it do to put that poorly recorded source into a great room? >I'd suggest that the first thing to deal with is correcting these bad rooms with Virtual Rooms. You know, crap in equals crap out. I'm not sure whay you mean by "Virtual Room" in this context. My program can be used to create virtual rooms. The way I handle bad recordings (after trying not to do that) is to superimpose a frequency spectrum on top of the frequency response of the virtual room that I created in my 3-D program. In other words, as long as it's a linear process (as Steve said), you can combine everything into the same frequency response, then obtain a single impulse response function that both corrects any tuning type of problem (as well as whatever else you want to throw in) and models a 3-D environment complete with a frequency-dependent decay. It's all part of the same process of getting the total environment set up correctly. You then look at test signals recorded in your non-optimum setting, passed through the wonderful IR you've created, and everything sounds --- uh, sort of OK. Another thing one can do is to model the crappy room backwards in time. You would ask yourself, "What crappy signal do I need to create at the source to produce a good signal at location (x,y,z)?" The impulse response function for that case can be generated, and it can be used to "correct" problems. Now not all problems can be corrected, but certainly incorrect frequency responses can be. This is what one is actually doing with a multi-band equalizer. Another consideration that many audio engineers overlook is that most people listen to most music in crappy listening environments --- like MP3's with cheap headphones or in a car with the A/C going. Most of these crappy listening environments completely swamp out everything that the audio engineers did to make the sound as good as it can be. But there is a possible solution to that: To some extent, a known crappy environment such as the typical American living room can be somewhat corrected by the backwards-in-time (retrodiction) room modelling. Admittedly, there are a number of problems that cannot be corrected, but: Room modelling has a number of applications, not just determining the frequency response of an ideal concert hall. >The question I can't answer is, can Virtual Rooms sounds as good as physical rooms that are tuned? That's a multimillion dollar question, isn't it? I'd like to find out, which is the real reason why I created these programs in the first place. So far, it sounds even better than I had hoped for. ----------------------------- [*] The ability to model both instruments and the environment leads to the "rethinking" of the entire process that I referred to in an earlier mailing. If you can model the instruments, then you don't necessarily need to play them in the time sequence of a recording. "Recording" of the audio doesn't exist any more. It's more of an assembly or compilation process. However, artists need not worry because one still needs to perform the score which does need to be recorded somehow for a realistic performance.
