Hello - I just installed a new HDSP multiface with PCI on a PlanetCCRMA/FC3 box, kernel 2.6.8.1-1.520.2vS7.ll, ALSA 1.07 (homemade rpms) and am not seeing any output levels on HDSPmixer (bottom row) despite actually hearing the signal I expect (sounds great). Modules/firmware load beautifully, I can route signal with HDSPmixer as expected, adjust levels, etc, just no visual feedback from the outputs row either with vu levels or changing peak values. Also on mixer channels that do show vu's (input and internal, top and middle rows respectively) the yellow peak indicators appear only randomly every 2-3 seconds or so, sort or popping around without any clear relation to the signal peak. Something's not right here. /sbin/lspci: 02:0d.0 Multimedia audio controller: Xilinx Corporation RME Hammerfall DSP (rev 0b) cat /proc/pci: Bus 2, device 13, function 0: Class 0401: PCI device 10ee:3fc5 (rev 11). IRQ 5. Master Capable. Latency=255. Non-prefetchable 32 bit memory at 0xec800000 [0xec80ffff]. "proc/interrupts says the card is on it's own interrupt, IRQ 5. Kevin
