Hi Kai,
On 16/01/2016 21:50, Kai Vehmanen wrote:
Hi Lorenzo,
On Sat, 16 Jan 2016, Lorenzo Sutton wrote:
ecasound -c -i ultimo_sole_audio_dial_eff.wav -o jack,system \
-G:jack,ecasound,recv
[...]
1. The above starts in interactive mode while I'd like ecasound to
autostart when run. It seems that omitting -c will cause ecasound to
exit upon jack transport stop, which is a no-go for me
You can add "-E start" to handle this (see ecasound(1) man page for -E,
it allows you to pass set of initial commands to run, so designed
specifically to address this problem).
2. The wave file is mono: I tried various combinations sucj as
jack_multi but this will always either create two outputs or one
output and connect it only to one of the system (stereo) outputs.
Add "-chcopy:1,2" (see ecasound(1) man page for this as well) and
"-f:,2, -o jack,system". This will copy left channel contents to the
right, and output
a stereo stream to JACK.
Thanks for your very helpful suggestions. Those options totally slipped
when reading the man.
Lorenzo.
_______________________________________________
Linux-audio-user mailing list
Linux-audio-user@xxxxxxxxxxxxxxxxxxxx
http://lists.linuxaudio.org/listinfo/linux-audio-user
