Re: send a midi CC signal to my midi controller from bash

[Athanasios Silis <athanasios.silis@xxxxxxxxx>]

thank you Ralph, i'll look into it.

I took a midi dump (through arecordmidi) from my BCR2000 controller and realised while reading the midi file that 2 byte values are stored locally in a midi file lsb first. This is opposite to what I see here http://www.somascape.org/midi/tech/mfile.html#midi . for example the midi MThd : Header chunk, was written in the midi file as  54 4D 64 68 . and chunklen as 00 00 06 00 . So this is one thing that I should keep in mind when I send hex numbers.

also based on your analysis, can I just forget about all those headers when I send a midi cc command? can I just send the midi even directly?

yes writing a function is not too hard = i do work in low lelvel programming after all, biut I dunno if by mistake I send some cmd that can fuck up the controller :)

On Tue, Oct 13, 2015 at 2:05 AM, Ralf Mardorf <ralf.mardorf@xxxxxxxxxxxxx> wrote:

Begin forwarded message:

Date: Tue, 13 Oct 2015 00:57:15 +0200
From: Ralf Mardorf <ralf.mardorf@xxxxxxxxxxxxx>
To: Athanasios Silis <athanasios.silis@xxxxxxxxx>
Subject: Re: send a midi CC signal to my midi controller from bash

Control Change bits of the three bytes are

Byte 1, nnnn is for channel 0 to 15

1011 nnnn

Byte 2, ccc cccc number of controller

0ccc cccc

Byte 3, vvv vvvv value

0vvv vvvv

It's not too hard to write a function using amidi that allows you to use
it like that

my_function interface channel controller value

my_function 0 10 7 127

It's comfortable to have a function that alows
values from -63 to 0 to 64 and
values from 0 to 127.

Unfortunately I don't have time to search my scripts for such a
function, but IIRC it wasn't hard to write it.

_______________________________________________
Linux-audio-user mailing list
Linux-audio-user@xxxxxxxxxxxxxxxxxxxx
http://lists.linuxaudio.org/listinfo/linux-audio-user