On Thu, 2004-08-12 at 18:02, jmacdermott@xxxxxxxxxxxxxxx wrote: > Hey folks, just wanted to follow up and thank those that made suggestions - I > have both soundcards working with qjackctl & ardour, and life is once again > good! > > Two new questions though: > > 1. My Delta 1010LT is HW0 and the onboard sound chip is HW1. Is there any way > for qjackctl to access both at the same time (ie: use the Delta's inputs and > have the output run through my computer's regular speakers)? If your refering to the "system speaker"...I don't think so but depends on your setup... > > 2. Does anyone have a quick reference to the 12 ins and 10 outs on the card so > that I don't have to test each track individually? :-) I have this same setup thanks to Jan. The first 8 analogue In's and outs of the card correspond directly to the first 8 pcm in's and out's in the Qjackctl "connect" window. In Envy24control mixer "analogue" levels window, input 1 in Qjackctl will correspond to "adc 0", in 2 to "adc 1, etc. I have not used the spdif functions of my card...or any toher card for that matter...I assume I/O's 9,10 then 11 and 12 are for digital functions. I don't worry about them. I was going to dig thru the .asoundrc and figure out what needs taken out eliminate the channels I don't use but again..."If it ain't broke, Don't fix it!" Cheers R~ > > Thanks again everyone! Oh, and AudioSlack is GREAT! > > Jay
