On 03/05/2015 00:06, Ralf Mardorf wrote:
On Sat, 02 May 2015 23:51:22 +0200, Anton Curl wrote:
This is what I have in my .jackdrc.
In command line, there is no problem. It works perfectly. But if I try
to launch Jack with this parameters through QJackCtl
Do you use this settings, or do you expect that QjackCtl does use the
settings stored in ~/.jackdrc?
QjackCtl does not use the settings stored in ~/.jackdrc, it does use
the settings stored in ~/.config/rncbc.org/QjackCtl.conf .
Yes, but QJackCtl wrote this file, not me. So if I run this command, I
run the same command that QJackCtl uses to start jackd.
On 03/05/2015 02:05, Chris Caudle wrote:
On Sat, May 2, 2015 4:51 pm, Anton Curl wrote:
/usr/bin/jackd -P80 -dalsa -r44100 -p256 -n2 -Xseq -D -Chw:5,1
-Phw:5,0
In command line, there is no problem. It works perfectly. But if I try
to launch Jack with this parameters through QJackCtl, I get this in the
message window:
creating alsa driver ...
hw:5,1|hw:5,1|256|3|44100|0|0|nomon|swmeter|-|32bit
The 5.0 output becomes 5.1. I don't understand why.
In the QJackControl setup dialog, did you select different input and
output hardware device?
Yes,
Input: hw:5.1
Output: hw:5.0
And duplex is also set.
Anton Curl
_______________________________________________
Linux-audio-user mailing list
Linux-audio-user@xxxxxxxxxxxxxxxxxxxx
http://lists.linuxaudio.org/listinfo/linux-audio-user
