Re: [PATCH 2/2] interconnect: qcom: Add SM8450 interconnect provider driver

[Georgi Djakov <djakov@xxxxxxxxxx>]

Hi Vinod,

Thanks for working on this!

On 1.12.21 9:25, Vinod Koul wrote:
> Add driver for the Qualcomm interconnect buses found in SM8450 based
> platforms. The topology consists of several NoCs that are controlled by
> a remote processor that collects the aggregated bandwidth for each
> master-slave pairs.
>
> This is based on the downstream driver by
> Vivek Aknurwar <viveka@xxxxxxxxxxxxxx>

Maybe CC him too.

> Signed-off-by: Vinod Koul <vkoul@xxxxxxxxxx>
> ---
>   drivers/interconnect/qcom/Kconfig  |    9 +
>   drivers/interconnect/qcom/Makefile |    2 +
>   drivers/interconnect/qcom/sm8450.c | 1988 ++++++++++++++++++++++++++++
>   drivers/interconnect/qcom/sm8450.h |  169 +++
>   4 files changed, 2168 insertions(+)
>   create mode 100644 drivers/interconnect/qcom/sm8450.c
>   create mode 100644 drivers/interconnect/qcom/sm8450.h
[..]
> +static struct platform_driver qnoc_driver = {
> +	.probe = qnoc_probe,
> +	.remove = qnoc_remove,
> +	.driver = {
> +		.name = "qnoc-sm8450",
> +		.of_match_table = qnoc_of_match,
> +		.sync_state = icc_sync_state,

We should set this callback only after we enable the client drivers to
request bandwidth. Otherwise some path might get disabled because of no
users. I would suggest to add sync_state after we describe the paths in
DT.

Thanks,
Georgi