Hi,
> This change adds optimazation in init sequence for WCN6750.
you need to explain what you are doing.
>
> Signed-off-by: pharish <pharish@xxxxxxxxxxxxxx>
> ---
> drivers/bluetooth/hci_qca.c | 18 +++++++++++-------
> 1 file changed, 11 insertions(+), 7 deletions(-)
>
> diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
> index 6f44b26..4dedaaa 100644
> --- a/drivers/bluetooth/hci_qca.c
> +++ b/drivers/bluetooth/hci_qca.c
> @@ -1603,15 +1603,19 @@ static int qca_regulator_init(struct hci_uart *hu)
> */
> qcadev = serdev_device_get_drvdata(hu->serdev);
> if (!qcadev->bt_power->vregs_on) {
> - serdev_device_close(hu->serdev);
> + if (qca_is_wcn399x(soc_type))
> + serdev_device_close(hu->serdev);
> +
> ret = qca_regulator_enable(qcadev);
> if (ret)
> return ret;
>
> - ret = serdev_device_open(hu->serdev);
> - if (ret) {
> - bt_dev_err(hu->hdev, "failed to open port");
> - return ret;
> + if (qca_is_wcn399x(soc_type)) {
> + ret = serdev_device_open(hu->serdev);
> + if (ret) {
> + bt_dev_err(hu->hdev, "failed to open port");
> + return ret;
> + }
I am really not doing this. You need to stop doing this SoC X or SoC Y crap. I said this before and I am saying this again, start from scratch and write a clean serdev only driver. Adding things to hci_qca is just a hack.
> }
> }
>
> @@ -1635,9 +1639,8 @@ static int qca_regulator_init(struct hci_uart *hu)
> }
> }
>
> - qca_set_speed(hu, QCA_INIT_SPEED);
> -
> if (qca_is_wcn399x(soc_type)) {
> + qca_set_speed(hu, QCA_INIT_SPEED);
> ret = qca_send_power_pulse(hu, true);
> if (ret)
> return ret;
> @@ -1648,6 +1651,7 @@ static int qca_regulator_init(struct hci_uart *hu)
> * Without this, we will have RTS and CTS synchronization
> * issues.
> */
> +
Unrelated change.
> serdev_device_close(hu->serdev);
> ret = serdev_device_open(hu->serdev);
> if (ret) {
Regards
Marcel
