[net-next PATCH v6 07/16] dt-bindings: net: dsa: qca8k: Document qca,sgmii-enable-pll

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Document qca,sgmii-enable-pll binding used in the CPU nodes to
enable SGMII PLL on MAC config.

Signed-off-by: Ansuel Smith <ansuelsmth@xxxxxxxxx>
---
 Documentation/devicetree/bindings/net/dsa/qca8k.txt | 10 ++++++++++
 1 file changed, 10 insertions(+)

diff --git a/Documentation/devicetree/bindings/net/dsa/qca8k.txt b/Documentation/devicetree/bindings/net/dsa/qca8k.txt
index aeb206556f54..05a8ddfb5483 100644
--- a/Documentation/devicetree/bindings/net/dsa/qca8k.txt
+++ b/Documentation/devicetree/bindings/net/dsa/qca8k.txt
@@ -45,6 +45,16 @@ A CPU port node has the following optional node:
                                 Mostly used in qca8327 with CPU port 0 set to
                                 sgmii.
 - qca,sgmii-txclk-falling-edge: Set the transmit clock phase to falling edge.
+- qca,sgmii-enable-pll  : For SGMII CPU port, explicitly enable PLL, TX and RX
+                          chain along with Signal Detection.
+                          This should NOT be enabled for qca8327. If enabled with
+                          qca8327 the sgmii port won't correctly init and an err
+                          is printed.
+                          This can be required for qca8337 switch with revision 2.
+                          A warning is displayed when used with revision greater
+                          2.
+                          With CPU port set to sgmii and qca8337 it is advised
+                          to set this unless a communication problem is observed.
 
 For QCA8K the 'fixed-link' sub-node supports only the following properties:
 
-- 
2.32.0




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux