[PATCH 09/10] backlight: qcom-wled: Consistently use enabled-strings in set_brightness

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



The hardware is capable of controlling any non-contiguous sequence of
LEDs specified in the DT using qcom,enabled-strings as u32
array, and this also follows from the DT-bindings documentation.  The
numbers specified in this array represent indices of the LED strings
that are to be enabled and disabled.

Its value is appropriately used to setup and enable string modules, but
completely disregarded in the set_brightness paths which only iterate
over the number of strings linearly.
Take an example where only string 2 is enabled with
qcom,enabled_strings=<2>: this string is appropriately enabled but
subsequent brightness changes would have only touched the zero'th
brightness register because num_strings is 1 here.  This is simply
addressed by looking up the string for this index in the enabled_strings
array just like the other codepaths that iterate over num_strings.

Fixes: 775d2ffb4af6 ("backlight: qcom-wled: Restructure the driver for WLED3")
Fixes: 03b2b5e86986 ("backlight: qcom-wled: Add support for WLED4 peripheral")
Signed-off-by: Marijn Suijten <marijn.suijten@xxxxxxxxxxxxxx>
Reviewed-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@xxxxxxxxxxxxxx>
---
 drivers/video/backlight/qcom-wled.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/video/backlight/qcom-wled.c b/drivers/video/backlight/qcom-wled.c
index dbe503007ada..c0b8d10c20a2 100644
--- a/drivers/video/backlight/qcom-wled.c
+++ b/drivers/video/backlight/qcom-wled.c
@@ -237,7 +237,7 @@ static int wled3_set_brightness(struct wled *wled, u16 brightness)
 
 	for (i = 0; i < wled->cfg.num_strings; ++i) {
 		rc = regmap_bulk_write(wled->regmap, wled->ctrl_addr +
-				       WLED3_SINK_REG_BRIGHT(i),
+				       WLED3_SINK_REG_BRIGHT(wled->cfg.enabled_strings[i]),
 				       &v, sizeof(v));
 		if (rc < 0)
 			return rc;
@@ -259,7 +259,7 @@ static int wled4_set_brightness(struct wled *wled, u16 brightness)
 
 	for (i = 0; i < wled->cfg.num_strings; ++i) {
 		rc = regmap_bulk_write(wled->regmap, wled->sink_addr +
-				       WLED4_SINK_REG_BRIGHT(i),
+				       WLED4_SINK_REG_BRIGHT(wled->cfg.enabled_strings[i]),
 				       &v, sizeof(v));
 		if (rc < 0)
 			return rc;
-- 
2.33.0




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux