Re: [PATCH 1/3] mfd: qcom-pm8xxx: switch away from using chained IRQ handlers

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 02/10/2021 04:08, Dmitry Baryshkov wrote:
PM8xxx PMIC family uses GPIO as parent IRQ. Using it together with the
irq_set_chained_handler_and_data() results in warnings from the GPIOLIB
as in this path the IRQ resources are not allocated (and thus the
corresponding GPIO is not marked as used for the IRQ. Use request_irq so
that the IRQ resources are proprely setup.

Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>

Please ignore this duplicate, it was sent by mistake.


--
With best wishes
Dmitry



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux