Some device can have some thermal sensor disabled from the factory. The current 2 irq handler functions check all the sensor by default and the check if the sensor was actually registered is wrong. The tzd is actually never set if the registration fail hence the IS_ERR check is wrong. Signed-off-by: Ansuel Smith <ansuelsmth@xxxxxxxxx> Reviewed-by: Matthias Kaehlcke <mka@xxxxxxxxxxxx> --- drivers/thermal/qcom/tsens.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/thermal/qcom/tsens.c b/drivers/thermal/qcom/tsens.c index 4c7ebd1d3f9c..b1162e566a70 100644 --- a/drivers/thermal/qcom/tsens.c +++ b/drivers/thermal/qcom/tsens.c @@ -417,7 +417,7 @@ static irqreturn_t tsens_critical_irq_thread(int irq, void *data) const struct tsens_sensor *s = &priv->sensor[i]; u32 hw_id = s->hw_id; - if (IS_ERR(s->tzd)) + if (!s->tzd) continue; if (!tsens_threshold_violated(priv, hw_id, &d)) continue; @@ -467,7 +467,7 @@ static irqreturn_t tsens_irq_thread(int irq, void *data) const struct tsens_sensor *s = &priv->sensor[i]; u32 hw_id = s->hw_id; - if (IS_ERR(s->tzd)) + if (!s->tzd) continue; if (!tsens_threshold_violated(priv, hw_id, &d)) continue; -- 2.32.0