Hi Marcel,
On 2021-08-16 21:37, Marcel Holtmann wrote:
Hi Balakrishna,
This change sets SSR triggered flags when QCA SSR command is sent to
SoC. After the SSR command sent, driver discards the incoming data
from
the upper layers. This way will ensure to read full dumps from the
BT SoC without any flow control issues due to excess of data receiving
from the HOST in audio usecases.
Signed-off-by: Balakrishna Godavarthi <bgodavar@xxxxxxxxxxxxxx>
---
drivers/bluetooth/hci_qca.c | 10 ++++++++++
1 file changed, 10 insertions(+)
diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
index 53deea2..5cbed6a 100644
--- a/drivers/bluetooth/hci_qca.c
+++ b/drivers/bluetooth/hci_qca.c
@@ -69,6 +69,8 @@
#define QCA_LAST_SEQUENCE_NUM 0xFFFF
#define QCA_CRASHBYTE_PACKET_LEN 1096
#define QCA_MEMDUMP_BYTE 0xFB
+#define QCA_SSR_OPCODE 0xFC0C
+#define QCA_SSR_PKT_LEN 5
enum qca_flags {
QCA_IBS_DISABLED,
@@ -871,6 +873,14 @@ static int qca_enqueue(struct hci_uart *hu,
struct sk_buff *skb)
/* Prepend skb with frame type */
memcpy(skb_push(skb, 1), &hci_skb_pkt_type(skb), 1);
+ if (hci_skb_pkt_type(skb) == HCI_COMMAND_PKT &&
+ skb->len == QCA_SSR_PKT_LEN &&
+ hci_skb_opcode(skb) == QCA_SSR_OPCODE) {
+ bt_dev_info(hu->hdev, "Triggering ssr");
+ set_bit(QCA_SSR_TRIGGERED, &qca->flags);
+ set_bit(QCA_MEMDUMP_COLLECTION, &qca->flags);
+ }
+
can we please stop hacking around by parsing opcodes in an enqueue
function. Sounds like someone is injecting raw HCI vendor commands and
then having a driver react to it.
[Bala]: yes this opcode is injected via hcitool to test BT SoC dump
procedure or
to collect the dumps to debug the issue during issue cases. When audio
usecases are running,
HOST sends ACL packets to SoC, in meantime if this command is sent to
SoC using hcitool
to collect dumps at particular point, With out this check HOST is
pumping continues data to
SoC and SoC RFR line goes high, sometimes SoC become unresponsive and
driver starts logging
command timeout error. Instead here, once a cmd with this opcode is
sent, timer is started
to ensure that SSR is in progress. If no response from SoC for 8
seconds. Driver will be restarted.
Regards
Marcel
