Re: [PATCH 0/8] cpufreq: Auto-register with energy model

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Wednesday 11 Aug 2021 at 14:43:21 (+0530), Viresh Kumar wrote:
> On 11-08-21, 09:37, Quentin Perret wrote:
> > On Wednesday 11 Aug 2021 at 10:48:59 (+0530), Viresh Kumar wrote:
> > > I had to use the pm-opp version, since almost everyone was using that.
> > > 
> > > On the other hand, there isn't a lot of OPP specific stuff in
> > > dev_pm_opp_of_register_em(). It just uses dev_pm_opp_get_opp_count(),
> > > that's all. This ended up in the OPP core, nothing else. Maybe we can
> > > now move it back to the EM core and name it differently ?
> > 
> > Well it also uses dev_pm_opp_find_freq_ceil() and
> > dev_pm_opp_get_voltage(), so not sure how easy it will be to move, but
> > if it is possible no objection from me.
> 
> What uses these routines ? dev_pm_opp_of_register_em() ? I am not able
> to see that at least :(

Yep, it's not immediately obvious, but see how it sets the struct
em_data_callback to point at _get_power() where the actual energy
calculation is done. So strictly speaking _get_power() is what uses
these routines, but it goes in hand with dev_pm_opp_of_register_em() so
I guess the same reasoning applies.

> > Right but the EM is a description of the hardware, so it seemed fair
> > to assume this wouldn't change across the lifetime of the OS, similar
> > to the DT which we can't reload at run-time. Yes it can be a little odd
> > if you load/unload your driver module, but note that you generally can't
> > load two completely different drivers on a single system. You'll just
> > load the same one again and the hardware hasn't changed in the meantime,
> > so the previously loaded EM will still be correct.
> 
> Yeah, it will be the same driver but a different version of it, which
> may have updated the freq table. For me the EM is attached to the
> freq-table, and the freq-table is not available anymore after the
> driver is gone.
> 
> Anyway, I will leave that for you guys to decide :)

IIUC Lukasz is working on something that should allow changing the EM at
run-time, so hopefully it'll enable this use-case as well, but we'll see :)



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux