On 8/10/21 8:36 AM, Viresh Kumar wrote:
Use the CPUFREQ_REGISTER_WITH_EM flag to allow cpufreq core to
automatically register with the energy model.
This allows removal of boiler plate code from the driver and fixes the
unregistration part as well.
Signed-off-by: Viresh Kumar <viresh.kumar@xxxxxxxxxx>
---
drivers/cpufreq/qcom-cpufreq-hw.c | 5 ++---
1 file changed, 2 insertions(+), 3 deletions(-)
diff --git a/drivers/cpufreq/qcom-cpufreq-hw.c b/drivers/cpufreq/qcom-cpufreq-hw.c
index f86859bf76f1..221433c6dcb0 100644
--- a/drivers/cpufreq/qcom-cpufreq-hw.c
+++ b/drivers/cpufreq/qcom-cpufreq-hw.c
@@ -362,8 +362,6 @@ static int qcom_cpufreq_hw_cpu_init(struct cpufreq_policy *policy)
goto error;
}
- dev_pm_opp_of_register_em(cpu_dev, policy->cpus);
-
if (policy_has_boost_freq(policy)) {
ret = cpufreq_enable_boost_support();
if (ret)
@@ -406,7 +404,8 @@ static struct freq_attr *qcom_cpufreq_hw_attr[] = {
static struct cpufreq_driver cpufreq_qcom_hw_driver = {
.flags = CPUFREQ_NEED_INITIAL_FREQ_CHECK |
CPUFREQ_HAVE_GOVERNOR_PER_POLICY |
- CPUFREQ_IS_COOLING_DEV,
+ CPUFREQ_IS_COOLING_DEV |
+ CPUFREQ_REGISTER_WITH_EM,
.verify = cpufreq_generic_frequency_table_verify,
.target_index = qcom_cpufreq_hw_target_index,
.get = qcom_cpufreq_hw_get,
Reviewed-by: Lukasz Luba <lukasz.luba@xxxxxxx>
