[PATCH v2] arm64: dts: qcom: pm6150: Add thermal zone for PMIC on-die temperature

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Add a thermal zone for the pm6150 on-die temperature. The system should
try to shut down orderly when the temperature reaches the critical trip
point at 115°C, otherwise the PMIC will perform a HW power off at 145°C.

Signed-off-by: Matthias Kaehlcke <mka@xxxxxxxxxxxx>
---

Changes in v2:
- remove 'pm6150-' prefix from critical trip point
- updated commit message

 arch/arm64/boot/dts/qcom/pm6150.dtsi | 24 ++++++++++++++++++++++++
 1 file changed, 24 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/pm6150.dtsi b/arch/arm64/boot/dts/qcom/pm6150.dtsi
index 8ab4f1f78bbf..8a4972e6a24c 100644
--- a/arch/arm64/boot/dts/qcom/pm6150.dtsi
+++ b/arch/arm64/boot/dts/qcom/pm6150.dtsi
@@ -7,6 +7,30 @@
 #include <dt-bindings/spmi/spmi.h>
 #include <dt-bindings/thermal/thermal.h>
 
+/ {
+	thermal-zones {
+		pm6150_thermal: pm6150-thermal {
+			polling-delay-passive = <100>;
+			polling-delay = <0>;
+			thermal-sensors = <&pm6150_temp>;
+
+			trips {
+				pm6150_trip0: trip0 {
+					temperature = <95000>;
+					hysteresis = <0>;
+					type = "passive";
+				};
+
+				pm6150_crit: crit {
+					temperature = <115000>;
+					hysteresis = <0>;
+					type = "critical";
+				};
+			};
+		};
+	};
+};
+
 &spmi_bus {
 	pm6150_lsid0: pmic@0 {
 		compatible = "qcom,pm6150", "qcom,spmi-pmic";
-- 
2.32.0.rc0.204.g9fa02ecfa5-goog




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux