On Tue, 11 May 2021 at 20:08, Jonathan Marek <jonathan@xxxxxxxx> wrote:
>
> csid_isr() only checks for the reset irq, so enabling any other irqs
> doesn't make sense. The "RDI irq" comment is also wrong, the register
> should be CSID_CSI2_RDIN_IRQ_MASK. Without this fix there may be an
> excessive amount of irqs.
>
> Fixes: eebe6d00e9bf ("media: camss: Add support for CSID hardware version Titan 170")
> Signed-off-by: Jonathan Marek <jonathan@xxxxxxxx>
> ---
> drivers/media/platform/qcom/camss/camss-csid-170.c | 6 ------
> 1 file changed, 6 deletions(-)
>
> diff --git a/drivers/media/platform/qcom/camss/camss-csid-170.c b/drivers/media/platform/qcom/camss/camss-csid-170.c
> index a81cc94c075f..2bc695819919 100644
> --- a/drivers/media/platform/qcom/camss/camss-csid-170.c
> +++ b/drivers/media/platform/qcom/camss/camss-csid-170.c
> @@ -443,12 +443,6 @@ static void csid_configure_stream(struct csid_device *csid, u8 enable)
> val |= 1 << CSI2_RX_CFG1_MISR_EN;
> writel_relaxed(val, csid->base + CSID_CSI2_RX_CFG1); // csi2_vc_mode_shift_val ?
>
> - /* error irqs start at BIT(11) */
> - writel_relaxed(~0u, csid->base + CSID_CSI2_RX_IRQ_MASK);
> -
> - /* RDI irq */
> - writel_relaxed(~0u, csid->base + CSID_TOP_IRQ_MASK);
> -
> val = 1 << RDI_CTRL_HALT_CMD;
> writel_relaxed(val, csid->base + CSID_RDI_CTRL(0));
> }
Reviewed-by: Robert Foss <robert.foss@xxxxxxxxxx>
