Hi Mike, On Wed, Mar 24, 2021 at 09:22:31PM +0000, Mike Leach wrote: > Hi Leo, > > There are additional CTI components on the DB410c - I think there is > information on base addresses for these - but there is no information > on connectivity between the CTIs and any components such as STM / ETR > etc for any of the in / out signal lines. > Therefore we omitted these from the original DT when adding the other > CTI devices. > > It could well be that there are signals from the STM to a CTI, and if > the information could be found then it would be useful to add - but I > have not seen this information anywhere - and it is the sort of thing > that is often missed out of hardware manuals. > It might be possible to deduce some information using the Coresight > intergration management registers - but this would involve a lot of > trial and error testing Okay, let's firstly merge the STM binding patch and later can consider to enable DT binding between CTI and STM if have sufficient info. Thanks a lot for confirmation. Leo
