Hi Bryan, Thanks for your work! On 3/12/21 7:30 PM, Bryan O'Donoghue wrote: > V2: > - Adds Acked-by as indicated - Stan > - Fixes typo in patch #1 22000000 -> 220000000 - Stan > - Fixes setting of clk_set_rate in core_clks_enable > unbreaks regression for 1xx/db410c - Stan > - "Add 6xx AXI halt logic" > * Polled read removed - Stan > * Redundant comments removed - Stan > * Delay assocaited with LPI write removed entirely > experimentation shows a delay is not required - Stan/Bryan > - Unifies intbuf_types_6xx_enc and intbuf_types_6xx_dec into > intbuf_types_6xx > Looking at the code the separate arrays was a NOP anyway - Stan/Bryan > - Ensures venus_helper_set_format_constraints() runs for 6xx only > - Differentiates stop address between 6xx and >= 4xx > 0xdeadb000 >= 4xx > 0x00000000 == 6xx - Stan > > With the fixes in place for db410c I've verified this code now on > sm8250/rb5 sdm845/rb3 and msm8916/db410c You have my ack for all patches Acked-by: Stanimir Varbanov <stanimir.varbanov@xxxxxxxxxx> except 21/25 and 24/25 who have comments. > > yaml: pending - acked waiting application > https://www.spinics.net/lists/devicetree/msg406892.html I'll take this through media-tree once driver patchset is ready. -- regards, Stan > > dts: pending - will resend when above is applied > https://lore.kernel.org/linux-arm-msm/20210222132817.1807788-1-bryan.odonoghue@xxxxxxxxxx/T/#t > > Reference tree: > > ssh://git@xxxxxxxxxxxxxx/people/bryan.odonoghue/kernel.git / tracking-qcomlt-sm8250-venus > > This tree incorporates two sets of patches from Stan - plus the two > yaml/dts sets mentioned above. > > svarbanov-linux-tv/venus-for-next-v5.13 > svarbanov-linux-tv/venus-msm8916-fixes > > There's a small integration error between the 5.13 and msm8916-fixes which > I resolved in favor of the bugfix in 5.13 pending - other than that this > tree and these patches apply on tip-of-tree and run as indicated on rb5/rb3 > and db410c. > > https://www.spinics.net/lists/linux-arm-msm/msg81291.html > > V1: > This series enables support for 6xx venus encode/decode as found on the > sm8250. > > The new silicon has different base addresses for existing functional blocks > within the venus address space. We add a base address offset mechanism to > handle this. The offsetting mechanism has been validated on 6xx and 4xx > hardware. > > The sm8250 supports: > > - h264 > - h265 > - vp8 > - vp9 > > The driver changes are contingent on yaml and dts patches already > in-flight. > > yaml: pending > https://www.spinics.net/lists/devicetree/msg406892.html > > dts: pending > https://lore.kernel.org/linux-arm-msm/20210222132817.1807788-1-bryan.odonoghue@xxxxxxxxxx/T/#t > > clk: applied > https://kernel.googlesource.com/pub/scm/linux/kernel/git/clk/linux/+/clk-next > > Applies on top of > > https://git.linuxtv.org/svarbanov/media_tree.git / venus-for-next-v5.12-part2 > > Bryan O'Donoghue (11): > media: venus: Update v6 buffer descriptors > media: venus: core: add sm8250 DT compatible and resource data > media: venus: core: Add io base variables for each block > media: venus: hfi,pm,firmware: Convert to block relative addressing > media: venus: core: Add differentiator IS_V6(core) > media: venus: core: Add an io base for TZ wrapper regs > media: venus: core: Add an io base for AON regs > media: venus: core: Hook to V6 base registers when appropriate > media: venus: hfi: Read WRAPPER_TZ_CPU_STATUS_V6 on 6xx > media: venus: hfi, vdec: v6 Add IS_V6() to existing IS_V4() if > locations > media: venus: pm: Hook 6xx pm ops into 4xx pm ops > > Dikshita Agarwal (12): > media: venus: hfi: Define block offsets for V6 hardware > media: venus: hfi: Define additional 6xx registers > media: venus: hfi: Add a 6xx boot logic > media: venus: hfi: Add 6xx interrupt support > media: venus: core,pm: Vote for min clk freq during venus boot > media: venus: hfi: Add 6xx AXI halt logic > media: venus: pm: Toggle 6xx wrapper power in vcodec_control > media: venus: firmware: Do not toggle WRAPPER_A9SS_SW_RESET on 6xx > media: venus: helpers: Add internal buffer list for v6 > media: venus: helpers, hfi, vdec: Set actual plane constraints to FW > media: venus: hfi: Increase plat_buf_v6 o/p buffer count. > media: venus: helper: Decide work mode > > Stanimir Varbanov (2): > media: venus: core,pm: Add handling for resets > media: venus: vdec: Fix decoder cmd STOP issue > > drivers/media/platform/qcom/venus/core.c | 78 +++++++++ > drivers/media/platform/qcom/venus/core.h | 19 ++ > drivers/media/platform/qcom/venus/firmware.c | 34 ++-- > drivers/media/platform/qcom/venus/helpers.c | 73 +++++++- > drivers/media/platform/qcom/venus/helpers.h | 3 +- > drivers/media/platform/qcom/venus/hfi_cmds.c | 15 +- > .../media/platform/qcom/venus/hfi_helper.h | 9 +- > .../platform/qcom/venus/hfi_plat_bufs_v6.c | 2 +- > .../platform/qcom/venus/hfi_platform_v6.c | 138 +++++++-------- > drivers/media/platform/qcom/venus/hfi_venus.c | 164 +++++++++++++----- > .../media/platform/qcom/venus/hfi_venus_io.h | 118 ++++++++----- > .../media/platform/qcom/venus/pm_helpers.c | 92 +++++++++- > drivers/media/platform/qcom/venus/vdec.c | 17 +- > drivers/media/platform/qcom/venus/venc.c | 2 +- > 14 files changed, 567 insertions(+), 197 deletions(-) >
