On 2/17/21 2:40 PM, Ansuel Smith wrote:
Function compute_intercept_slope hardcode the sensor slope to
SLOPE_DEFAULT. Change this and use the default value only if a slope is
not defined. This is needed for tsens VER_0 that has a hardcoded slope
table.
Signed-off-by: Ansuel Smith <ansuelsmth@xxxxxxxxx>
Reviewed-by: Thara Gopinath <thara.gopinath@xxxxxxxxxx>
Warm Regards
Thara
---
drivers/thermal/qcom/tsens.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/drivers/thermal/qcom/tsens.c b/drivers/thermal/qcom/tsens.c
index f9126909892b..842f518fdf84 100644
--- a/drivers/thermal/qcom/tsens.c
+++ b/drivers/thermal/qcom/tsens.c
@@ -86,7 +86,8 @@ void compute_intercept_slope(struct tsens_priv *priv, u32 *p1,
"%s: sensor%d - data_point1:%#x data_point2:%#x\n",
__func__, i, p1[i], p2[i]);
- priv->sensor[i].slope = SLOPE_DEFAULT;
+ if (!priv->sensor[i].slope)
+ priv->sensor[i].slope = SLOPE_DEFAULT;
if (mode == TWO_PT_CALIB) {
/*
* slope (m) = adc_code2 - adc_code1 (y2 - y1)/
--
Warm Regards
Thara
