On 3/5/2021 7:09 AM, Loic Poulain wrote:
mhi_cntrl->timeout_ms is set by the controller and indicates the
maximum amount of time the controller device will take to be ready.
In case of PCI modems, this value is quite high given modems can take
up to 15 seconds from cold boot to be ready.
Reusing this value in mhi_pm_resume can cause huge resuming latency
and delay the whole system resume (in case of system wide suspend/
resume), leading to bad use experience.
I think this needs more explanation. The timeout is a maximum value.
You indicate that 2 seconds is more than enough for any MHI device to
exit M3 (citation needed), but 15 seconds is too much? The difference
should only be apparent when the device doesn't transition in the timeout.
Put another way, this doesn't say why 15 seconds is bad, if every device
only needs 2, given that wait_event_timeout() doesn't always wait for
the entire timeout value if the event occurs earlier.
This change adjusts the resume timeout to a fixed 2s value, which is
more than enough for any MHI device for exiting M3.
Signed-off-by: Loic Poulain <loic.poulain@xxxxxxxxxx>
---
drivers/bus/mhi/core/pm.c | 4 +++-
1 file changed, 3 insertions(+), 1 deletion(-)
diff --git a/drivers/bus/mhi/core/pm.c b/drivers/bus/mhi/core/pm.c
index 0cd6445..e2d83a9 100644
--- a/drivers/bus/mhi/core/pm.c
+++ b/drivers/bus/mhi/core/pm.c
@@ -17,6 +17,8 @@
#include <linux/wait.h>
#include "internal.h"
+#define MHI_PM_RESUME_TIMEOUT_MS 2000
+
/*
* Not all MHI state transitions are synchronous. Transitions like Linkdown,
* SYS_ERR, and shutdown can happen anytime asynchronously. This function will
@@ -942,7 +944,7 @@ int mhi_pm_resume(struct mhi_controller *mhi_cntrl)
ret = wait_event_timeout(mhi_cntrl->state_event,
mhi_cntrl->dev_state == MHI_STATE_M0 ||
MHI_PM_IN_ERROR_STATE(mhi_cntrl->pm_state),
- msecs_to_jiffies(mhi_cntrl->timeout_ms));
+ msecs_to_jiffies(MHI_PM_RESUME_TIMEOUT_MS));
if (!ret || MHI_PM_IN_ERROR_STATE(mhi_cntrl->pm_state)) {
dev_err(dev,
--
Jeffrey Hugo
Qualcomm Technologies, Inc. is a member of the
Code Aurora Forum, a Linux Foundation Collaborative Project.