The last cell of 'gpio-ranges' should be number of GPIO pins, and in
case of qcom platform it should match msm_pinctrl_soc_data.ngpio rather
than msm_pinctrl_soc_data.ngpio - 1.
This fixes the problem that when the last GPIO pin in the range is
configured with the following call sequence, it always fails with
-EPROBE_DEFER.
pinctrl_gpio_set_config()
pinctrl_get_device_gpio_range()
pinctrl_match_gpio_range()
Fixes: b7e8f433a673 ("arm64: dts: qcom: Add basic devicetree support for SM8350 SoC")
Cc: Vinod Koul <vkoul@xxxxxxxxxx>
Signed-off-by: Shawn Guo <shawn.guo@xxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/sm8350.dtsi | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/arch/arm64/boot/dts/qcom/sm8350.dtsi b/arch/arm64/boot/dts/qcom/sm8350.dtsi
index 5ef460458f5c..fab211298c35 100644
--- a/arch/arm64/boot/dts/qcom/sm8350.dtsi
+++ b/arch/arm64/boot/dts/qcom/sm8350.dtsi
@@ -382,7 +382,7 @@
#gpio-cells = <2>;
interrupt-controller;
#interrupt-cells = <2>;
- gpio-ranges = <&tlmm 0 0 203>;
+ gpio-ranges = <&tlmm 0 0 204>;
qup_uart3_default_state: qup-uart3-default-state {
rx {
--
2.17.1
