Re: [PATCH v6 1/4] bus: mhi: core: Destroy SBL devices when moving to mission mode

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 





On 2/24/21 3:23 PM, Bhaumik Bhatt wrote:
Currently, client devices are created in SBL or AMSS (mission
mode) and only destroyed after power down or SYS ERROR. When
moving between certain execution environments, such as from SBL
to AMSS, no clean-up is required. This presents an issue where
SBL-specific channels are left open and client drivers now run in
an execution environment where they cannot operate. Fix this by
expanding the mhi_destroy_device() to do an execution environment
specific clean-up if one is requested. Close the gap and destroy
devices in such scenarios that allow SBL client drivers to clean
up once device enters mission mode.

Signed-off-by: Bhaumik Bhatt <bbhatt@xxxxxxxxxxxxxx>
It make sense to clean up previous execution env related resources.

Reviewed-by: Hemant Kumar <hemantk@xxxxxxxxxxxxxx>

--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux