IPQ8074 needs support for secure pil as well. Also, currently only unified firmware is supported. IPQ8074 supports split firmware for q6 and m3, so adding support for that. This series is based on Govind's "[v9] Add non PAS wcss Q6 support for QCS404" changes since v8: - Rebased on top of linux-5.11-rc5 changes since v7: - Rebased on top of linux-5.9-rc2 changes since v6: - Rebased on top of the above mentioned dependant patch series changes since v5: - Rebased on top of linux-5.8-rc3 changes since v4: - Rebased patch 8 changes since v3: - In patch 10, Added release_firmware to free up memory requested for m3 firmware. changes since v2: - In patch 5, Added a driver data 'bcr_reset_required' to select if bcr reset is required - In patch 10, Removed syscon implementation and moved to mailbox framework to access APCS IPC changes since v1: - In patch 10, Addressed minor review comments. Gokul Sriram Palanisamy (9): remoteproc: qcom: Add PRNG proxy clock remoteproc: qcom: Add secure PIL support remoteproc: qcom: Add support for split q6 + m3 wlan firmware remoteproc: qcom: Add ssr subdevice identifier remoteproc: qcom: Update regmap offsets for halt register dt-bindings: clock: qcom: Add reset for WCSSAON clk: qcom: Add WCSSAON reset arm64: dts: Add support for scm on IPQ8074 SoCs arm64: dts: qcom: Enable Q6v5 WCSS for ipq8074 SoC arch/arm64/boot/dts/qcom/ipq8074.dtsi | 127 +++++++++++++++++++++ drivers/clk/qcom/gcc-ipq8074.c | 1 + drivers/remoteproc/qcom_q6v5_wcss.c | 162 +++++++++++++++++++++------ include/dt-bindings/clock/qcom,gcc-ipq8074.h | 1 + 4 files changed, 259 insertions(+), 32 deletions(-) -- 2.7.4
