When the BMC150 accelerometer/magnetometer was added to the device tree,
the sensors were working without specifying any regulator supplies,
likely because the regulators were on by default and then never turned off.
For some reason, this is no longer the case for pm8916_l17, which prevents
the sensors from working in some cases.
Now that the bmc150_accel/bmc150_magn drivers can enable necessary
regulators, declare the necessary regulator supplies to make the sensors
work again.
Fixes: 079f81acf10f ("arm64: dts: qcom: msm8916-samsung-a2015: Add accelerometer/magnetometer")
Signed-off-by: Stephan Gerhold <stephan@xxxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/msm8916-samsung-a2015-common.dtsi | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/msm8916-samsung-a2015-common.dtsi b/arch/arm64/boot/dts/qcom/msm8916-samsung-a2015-common.dtsi
index f91269492d72..f1af798abd74 100644
--- a/arch/arm64/boot/dts/qcom/msm8916-samsung-a2015-common.dtsi
+++ b/arch/arm64/boot/dts/qcom/msm8916-samsung-a2015-common.dtsi
@@ -106,6 +106,9 @@ accelerometer: accelerometer@10 {
interrupt-parent = <&msmgpio>;
interrupts = <115 IRQ_TYPE_EDGE_RISING>;
+ vdd-supply = <&pm8916_l17>;
+ vddio-supply = <&pm8916_l5>;
+
pinctrl-names = "default";
pinctrl-0 = <&accel_int_default>;
};
@@ -113,6 +116,9 @@ accelerometer: accelerometer@10 {
magnetometer@12 {
compatible = "bosch,bmc150_magn";
reg = <0x12>;
+
+ vdd-supply = <&pm8916_l17>;
+ vddio-supply = <&pm8916_l5>;
};
};
--
2.30.0
