From: Vinod Koul <vkoul@xxxxxxxxxx>
This adds DTS for PMIC PMX55 found in Qualcomm platforms.
Signed-off-by: Vinod Koul <vkoul@xxxxxxxxxx>
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
---
arch/arm/boot/dts/qcom-pmx55.dtsi | 91 +++++++++++++++++++++++++++++++
1 file changed, 91 insertions(+)
create mode 100644 arch/arm/boot/dts/qcom-pmx55.dtsi
diff --git a/arch/arm/boot/dts/qcom-pmx55.dtsi b/arch/arm/boot/dts/qcom-pmx55.dtsi
new file mode 100644
index 000000000000..05f033334716
--- /dev/null
+++ b/arch/arm/boot/dts/qcom-pmx55.dtsi
@@ -0,0 +1,91 @@
+// SPDX-License-Identifier: BSD-3-Clause
+
+/*
+ * Copyright (c) 2018-2020, The Linux Foundation. All rights reserved.
+ * Copyright (c) 2020, Linaro Limited
+ */
+
+#include <dt-bindings/iio/qcom,spmi-vadc.h>
+#include <dt-bindings/interrupt-controller/irq.h>
+#include <dt-bindings/spmi/spmi.h>
+
+&spmi_bus {
+ pmic@8 {
+ compatible = "qcom,pmx55", "qcom,spmi-pmic";
+ reg = <0x8 SPMI_USID>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ power-on@800 {
+ compatible = "qcom,pm8916-pon";
+ reg = <0x0800>;
+
+ status = "disabled";
+ };
+
+ pmx55_temp: temp-alarm@2400 {
+ compatible = "qcom,spmi-temp-alarm";
+ reg = <0x2400>;
+ interrupts = <0x8 0x24 0x0 IRQ_TYPE_EDGE_BOTH>;
+ io-channels = <&pmx55_adc ADC5_DIE_TEMP>;
+ io-channel-names = "thermal";
+ #thermal-sensor-cells = <0>;
+ };
+
+ pmx55_adc: adc@3100 {
+ compatible = "qcom,spmi-adc5";
+ reg = <0x3100>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+ #io-channel-cells = <1>;
+ interrupts = <0x8 0x31 0x0 IRQ_TYPE_EDGE_RISING>;
+
+ ref-gnd@0 {
+ reg = <ADC5_REF_GND>;
+ qcom,pre-scaling = <1 1>;
+ label = "ref_gnd";
+ };
+
+ vref-1p25@1 {
+ reg = <ADC5_1P25VREF>;
+ qcom,pre-scaling = <1 1>;
+ label = "vref_1p25";
+ };
+
+ die-temp@6 {
+ reg = <ADC5_DIE_TEMP>;
+ qcom,pre-scaling = <1 1>;
+ label = "die_temp";
+ };
+
+ chg-temp@9 {
+ reg = <ADC5_CHG_TEMP>;
+ qcom,pre-scaling = <1 1>;
+ label = "chg_temp";
+ };
+ };
+
+ pmx55_gpios: gpio@c000 {
+ compatible = "qcom,pmx55-gpio", "qcom,spmi-gpio";
+ reg = <0xc000>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
+ interrupts = <0x8 0xc0 0x0 IRQ_TYPE_NONE>,
+ <0x8 0xc1 0x0 IRQ_TYPE_NONE>,
+ <0x8 0xc3 0x0 IRQ_TYPE_NONE>,
+ <0x8 0xc4 0x0 IRQ_TYPE_NONE>,
+ <0x8 0xc5 0x0 IRQ_TYPE_NONE>,
+ <0x8 0xc7 0x0 IRQ_TYPE_NONE>,
+ <0x8 0xc8 0x0 IRQ_TYPE_NONE>;
+ };
+ };
+
+ pmic@9 {
+ compatible = "qcom,pmx55", "qcom,spmi-pmic";
+ reg = <0x9 SPMI_USID>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+ };
+};
--
2.25.1
