Re: [PATCH 2/4] mfd: qca639x: add support for QCA639x powerup sequence

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Mon, Dec 21, 2020 at 05:08:44PM +0300, Dmitry Baryshkov wrote:
> Hello,
> 
> On Mon, 21 Dec 2020 at 12:02, Lee Jones <lee.jones@xxxxxxxxxx> wrote:
> >
> > On Sun, 20 Dec 2020, Dmitry Baryshkov wrote:
> >
> > > Qualcomm QCA639x is a family of WiFi + Bluetooth SoCs, with BT part
> > > being controlled through the UART and WiFi being present on PCIe
> > > bus. Both blocks share common power sources. So add mfd device driver
> > > handling power sequencing of QCA6390/1.
> > >
> > > Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
> > > ---
> > >  drivers/mfd/Kconfig        |  12 +++
> > >  drivers/mfd/Makefile       |   1 +
> > >  drivers/mfd/qcom-qca639x.c | 168 +++++++++++++++++++++++++++++++++++++
> > >  3 files changed, 181 insertions(+)
> > >  create mode 100644 drivers/mfd/qcom-qca639x.c
> >
> > This is not an MFD, since it utilised neither the MFD API nor
> > of_platform_populate() to register child devices.
> 
> It would use them if the WiFi part was not on a discoverable bus.

PCI nodes have been supported in DT for forever. If you have 
non-discoverable additions to a PCI device, then the PCI device should 
be in DT.

Rob



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux