Switch reset pin of ov8856 node from GPIO_ACTIVE_HIGH to GPIO_ACTIVE_LOW,
this issue prevented the ov8856 from probing properly as it does not respond
to I2C messages.
Fixes: d4919a44564b ("arm64: dts: qcom: sdm845-db845c: Add ov8856 & ov7251
camera nodes")
Signed-off-by: Robert Foss <robert.foss@xxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/sdm845-db845c.dts | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/sdm845-db845c.dts b/arch/arm64/boot/dts/qcom/sdm845-db845c.dts
index 7cc236575ee2..a943b3f353ce 100644
--- a/arch/arm64/boot/dts/qcom/sdm845-db845c.dts
+++ b/arch/arm64/boot/dts/qcom/sdm845-db845c.dts
@@ -1112,11 +1112,11 @@ camera@10 {
reg = <0x10>;
// CAM0_RST_N
- reset-gpios = <&tlmm 9 0>;
+ reset-gpios = <&tlmm 9 1>;
pinctrl-names = "default";
pinctrl-0 = <&cam0_default>;
gpios = <&tlmm 13 0>,
- <&tlmm 9 0>;
+ <&tlmm 9 1>;
clocks = <&clock_camcc CAM_CC_MCLK0_CLK>;
clock-names = "xvclk";
--
2.27.0
