On 2020-12-02 04:15 PM, Hemant Kumar wrote:
Hi Bhaumik,
On 12/2/20 3:40 PM, Bhaumik Bhatt wrote:
Add support to receive the response to a STOP channel command to the
How about saying "Add support to send the STOP channel command ?
Addressed in v4.
MHI bus. If a client would like to STOP a channel instead of issuing
a RESET to it, this would provide support for it.
Signed-off-by: Bhaumik Bhatt <bbhatt@xxxxxxxxxxxxxx>
---
drivers/bus/mhi/core/main.c | 5 +++++
1 file changed, 5 insertions(+)
diff --git a/drivers/bus/mhi/core/main.c b/drivers/bus/mhi/core/main.c
index 702c31b..a7bb8a7 100644
--- a/drivers/bus/mhi/core/main.c
+++ b/drivers/bus/mhi/core/main.c
@@ -1193,6 +1193,11 @@ int mhi_send_cmd(struct mhi_controller
*mhi_cntrl,
cmd_tre->dword[0] = MHI_TRE_CMD_RESET_DWORD0;
cmd_tre->dword[1] = MHI_TRE_CMD_RESET_DWORD1(chan);
break;
+ case MHI_CMD_STOP_CHAN:
+ cmd_tre->ptr = MHI_TRE_CMD_STOP_PTR;
+ cmd_tre->dword[0] = MHI_TRE_CMD_STOP_DWORD0;
+ cmd_tre->dword[1] = MHI_TRE_CMD_STOP_DWORD1(chan);
+ break;
case MHI_CMD_START_CHAN:
cmd_tre->ptr = MHI_TRE_CMD_START_PTR;
cmd_tre->dword[0] = MHI_TRE_CMD_START_DWORD0;
Thanks,
Hemant
Thanks,
Bhaumik
---
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora
Forum,
a Linux Foundation Collaborative Project
