If a channel was explicitly stopped but not reset, allow it to move to a disabled state so that the channel context can be cleaned up after a driver remove is issued. Since the channel remained in stopped state, its context on the device is not cleared. Allow this move if a client driver module is unloaded or a device crash occurs. Signed-off-by: Bhaumik Bhatt <bbhatt@xxxxxxxxxxxxxx> Reviewed-by: Hemant Kumar <hemantk@xxxxxxxxxxxxxx> --- drivers/bus/mhi/core/init.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/drivers/bus/mhi/core/init.c b/drivers/bus/mhi/core/init.c index f0697f4..5c93a61 100644 --- a/drivers/bus/mhi/core/init.c +++ b/drivers/bus/mhi/core/init.c @@ -1288,7 +1288,8 @@ static int mhi_driver_remove(struct device *dev) mutex_lock(&mhi_chan->mutex); - if (ch_state[dir] == MHI_CH_STATE_ENABLED && + if ((ch_state[dir] == MHI_CH_STATE_ENABLED || + ch_state[dir] == MHI_CH_STATE_STOP) && !mhi_chan->offload_ch) mhi_deinit_chan_ctxt(mhi_cntrl, mhi_chan); -- The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project
