Hi Bhaumik, On Tue, 24 Nov 2020 at 01:52, Bhaumik Bhatt <bbhatt@xxxxxxxxxxxxxx> wrote: > > On 2020-11-23 06:10 AM, Loic Poulain wrote: > > This series adjust some configuration values to ensure stability and > > robustness of mhi pci devices (timeout, number of events, burst mode). > > > > It also includes support for system sleep as well as a recovery > > procedure > > that can be triggered when a PCI error is reported, either by PCI AER > > or by > > the new health-check mechanism. > > > > All these changes have been tested with Telit FN980m module. > > > > Loic Poulain (8): > > mhi: pci-generic: Increase number of hardware events > > mhi: pci-generic: Perform hard reset on remove > > mhi: pci_generic: Enable burst mode for hardware channels > > mhi: pci_generic: Add support for reset > > mhi: pci_generic: Add suspend/resume/recovery procedure > > mhi: pci_generic: Add PCI error handlers > > mhi: pci_generic: Add health-check > > mhi: pci_generic: Increase controller timeout value > > > > drivers/bus/mhi/pci_generic.c | 352 > > ++++++++++++++++++++++++++++++++++++++++-- > > 1 file changed, 335 insertions(+), 17 deletions(-) > Just noticed that you may have missed my reviewed-by on patches 1 and 8 > from the > previous submission. I don't find any reply to 1/8 or 8/8, could you please resubmit? Regards, Loic > > Thanks, > Bhaumik > --- > The Qualcomm Innovation Center, Inc. is a member of the Code Aurora > Forum, > a Linux Foundation Collaborative Project
