Re: [PATCH 20/20] arch: dts: Fix DWC USB3 DT nodes name

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Wed, Oct 14, 2020 at 01:35:16PM -0500, Rob Herring wrote:
> On Wed, Oct 14, 2020 at 9:37 AM Serge Semin
> <Sergey.Semin@xxxxxxxxxxxxxxxxxxxx> wrote:
> >
> > On Wed, Oct 14, 2020 at 05:09:37PM +0300, Felipe Balbi wrote:
> > >
> > > Hi Serge,
> > >
> > > Serge Semin <Sergey.Semin@xxxxxxxxxxxxxxxxxxxx> writes:
> > > > In accordance with the DWC USB3 bindings the corresponding node name is
> > > > suppose to comply with Generic USB HCD DT schema, which requires the USB
> > >
> >
> > > DWC3 is not a simple HDC, though.
> >
> > Yeah, strictly speaking it is equipped with a lot of vendor-specific stuff,
> > which are tuned by the DWC USB3 driver in the kernel. But after that the
> > controller is registered as xhci-hcd device so it's serviced by the xHCI driver,
> > which then registers the HCD device so the corresponding DT node is supposed
> > to be compatible with the next bindings: usb/usb-hcd.yaml, usb/usb-xhci.yaml
> > and usb/snps,dwc3,yaml. I've created the later one so to validate the denoted
> > compatibility.
> >
> > >
> > > > nodes to have the name acceptable by the regexp: "^usb(@.*)?" . But a lot
> > > > of the DWC USB3-compatible nodes defined in the ARM/ARM64 DTS files have
> > > > name as "^dwc3@.*" or "^usb[1-3]@.*" or even "^dwusb@.*", which will cause
> > > > the dtbs_check procedure failure. Let's fix the nodes naming to be
> > > > compatible with the DWC USB3 DT schema to make dtbs_check happy.
> > > >
> > > > Note we don't change the DWC USB3-compatible nodes names of
> > > > arch/arm64/boot/dts/apm/{apm-storm.dtsi,apm-shadowcat.dtsi} since the
> > > > in-source comment says that the nodes name need to be preserved as
> > > > "^dwusb@.*" for some backward compatibility.
> > >
> >
> > > interesting, compatibility with what? Some debugfs files, perhaps? :-)
> >
> > Don't really know.) In my experience the worst type of such compatibility is
> > connected with some bootloader magic, which may add/remove/modify properties
> > to nodes with pre-defined names.
> 

> I seriously doubt anyone is using the APM machines with DT (even ACPI
> is somewhat doubtful). I say change them. Or remove the dts files and
> see what happens. Either way it can always be reverted.

Ok. I'll change them in v3.

-Sergey

> 
> Rob



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux