Added support for HK10-C1 and HK10-C2 board variants based on IPQ8074 SoC. Both these variants support dual QCN9000 PCIe cards that uses MHI communication protocol over PCIe. In addition, HK10-C1 support on-chip radio. Both these variants slightly differ in clock configuation for ethernet. This series depends on below series: [V2,0/7] Add PCIe support for IPQ8074 [v7,0/9] remoteproc: qcom: q6v5-wcss: Add support for secure pil changes since v3: - Addressed build failure reported by test robot in patch 3 changes since v2: - In patch 3, Moved pcie0_rp and pcie1_rp nodes and removed unused members and subnodes Gokul Sriram Palanisamy (3): dt-bindings: qcom: Add ipq8074 bindings arm64: dts: Add board support for HK10 arm64: dts: Enabled MHI device over PCIe Documentation/devicetree/bindings/arm/qcom.yaml | 4 + arch/arm64/boot/dts/qcom/Makefile | 2 + arch/arm64/boot/dts/qcom/ipq8074-hk10-c1.dts | 11 +++ arch/arm64/boot/dts/qcom/ipq8074-hk10-c2.dts | 14 +++ arch/arm64/boot/dts/qcom/ipq8074-hk10.dtsi | 122 ++++++++++++++++++++++++ 5 files changed, 153 insertions(+) create mode 100644 arch/arm64/boot/dts/qcom/ipq8074-hk10-c1.dts create mode 100644 arch/arm64/boot/dts/qcom/ipq8074-hk10-c2.dts create mode 100644 arch/arm64/boot/dts/qcom/ipq8074-hk10.dtsi -- 2.7.4
