The mdss node sets #interrupt-cells = <1>, so its interrupts
should be referenced using a single cell (in this case: only the
interrupt number).
However, right now the mdp/dsi node both have two interrupt cells
set, e.g. interrupts = <4 0>. The 0 is probably meant to say
IRQ_TYPE_NONE (= 0), but with #interrupt-cells = <1> this is
actually interpreted as a second interrupt line.
Remove the IRQ flags from both interrupts to fix this.
Fixes: 305410ffd1b2 ("arm64: dts: msm8916: Add display support")
Signed-off-by: Stephan Gerhold <stephan@xxxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/msm8916.dtsi | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/msm8916.dtsi b/arch/arm64/boot/dts/qcom/msm8916.dtsi
index d84118fb4403..1f9a24a2464e 100644
--- a/arch/arm64/boot/dts/qcom/msm8916.dtsi
+++ b/arch/arm64/boot/dts/qcom/msm8916.dtsi
@@ -1068,7 +1068,7 @@ mdp: mdp@1a01000 {
reg-names = "mdp_phys";
interrupt-parent = <&mdss>;
- interrupts = <0 0>;
+ interrupts = <0>;
clocks = <&gcc GCC_MDSS_AHB_CLK>,
<&gcc GCC_MDSS_AXI_CLK>,
@@ -1100,7 +1100,7 @@ dsi0: dsi@1a98000 {
reg-names = "dsi_ctrl";
interrupt-parent = <&mdss>;
- interrupts = <4 0>;
+ interrupts = <4>;
assigned-clocks = <&gcc BYTE0_CLK_SRC>,
<&gcc PCLK0_CLK_SRC>;
--
2.28.0
