Re: [PATCH v1 1/2] scsi: dt-bindings: ufs: Add vcc-voltage-level for UFS

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 2020-09-13 02:35, Avri Altman wrote:


UFS's specifications supports a range of Vcc operating
voltage levels. Add documentation for the UFS's Vcc voltage
levels setting.

Signed-off-by: Can Guo <cang@xxxxxxxxxxxxxx>
Signed-off-by: Asutosh Das <asutoshd@xxxxxxxxxxxxxx>
Signed-off-by: Bao D. Nguyen <nguyenb@xxxxxxxxxxxxxx>
---
 Documentation/devicetree/bindings/ufs/ufshcd-pltfrm.txt | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/Documentation/devicetree/bindings/ufs/ufshcd-pltfrm.txt
b/Documentation/devicetree/bindings/ufs/ufshcd-pltfrm.txt
index 415ccdd..7257b32 100644
--- a/Documentation/devicetree/bindings/ufs/ufshcd-pltfrm.txt
+++ b/Documentation/devicetree/bindings/ufs/ufshcd-pltfrm.txt
@@ -23,6 +23,8 @@ Optional properties:
with "phys" attribute, provides phandle to UFS PHY node - vdd-hba-supply : phandle to UFS host controller supply regulator node
 - vcc-supply            : phandle to VCC supply regulator node
+- vcc-voltage-level     : specifies voltage levels for VCC supply.
For ufs3.1+ devices
Thanks for the comments, Avri.
I am not clear what this comment means. Could you please clarify?

+ Should be specified in pairs (min, max), units uV.
 - vccq-supply           : phandle to VCCQ supply regulator node
 - vccq2-supply          : phandle to VCCQ2 supply regulator node
- vcc-supply-1p8 : For embedded UFS devices, valid VCC range is 1.7-1.95V
--
Why are you removing all other docs?
They are still relevant for non ufs3.1 devices.
I did not remove anything. You may be confused by the "-" used as listing in the original document.



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux