On Fri, Jul 24, 2020 at 09:28:02AM +0530, satya priya wrote:
> As a part of system suspend we call uart_port_suspend from the
> Serial driver, which calls set_mctrl passing mctrl as NULL. This
> makes RFR high(NOT_READY) during suspend.
>
> Due to this BT SoC is not able to send wakeup bytes to UART during
> suspend. Included if check for non-suspend case to keep RFR low
> during suspend.
>
> Signed-off-by: satya priya <skakit@xxxxxxxxxxxxxx>
> ---
> Changes in V2:
> - This patch fixes the UART flow control issue during suspend.
> Newly added in V2.
>
> drivers/tty/serial/qcom_geni_serial.c | 2 +-
> 1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/drivers/tty/serial/qcom_geni_serial.c b/drivers/tty/serial/qcom_geni_serial.c
> index 07b7b6b..7108dfc 100644
> --- a/drivers/tty/serial/qcom_geni_serial.c
> +++ b/drivers/tty/serial/qcom_geni_serial.c
> @@ -242,7 +242,7 @@ static void qcom_geni_serial_set_mctrl(struct uart_port *uport,
> if (mctrl & TIOCM_LOOP)
> port->loopback = RX_TX_CTS_RTS_SORTED;
>
> - if (!(mctrl & TIOCM_RTS))
> + if ((!(mctrl & TIOCM_RTS)) && (!(uport->suspended)))
Why all these parentheses, instead of:
if (!(mctrl & TIOCM_RTS) && !uport->suspended)
?
