Re: [PATCH v2 2/5] iommu/arm-smmu: Emulate bypass by using context banks

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Mon, Jul 20, 2020 at 09:58:42AM +0100, Will Deacon wrote:
> On Thu, Jul 16, 2020 at 05:16:16PM -0700, Bjorn Andersson wrote:
> > Some firmware found on various Qualcomm platforms traps writes to S2CR
> > of type BYPASS and writes FAULT into the register. This prevents us from
> > marking the streams for the display controller as BYPASS to allow
> > continued scanout of the screen through the initialization of the ARM
> > SMMU.
> > 
> > This adds a Qualcomm specific cfg_probe function, which probes the
> > behavior of the S2CR registers and if found faulty enables the related
> > quirk. Based on this quirk context banks are allocated for IDENTITY
> > domains as well, but with ARM_SMMU_SCTLR_M omitted.
> > 
> > The result is valid stream mappings, without translation.
> > 
> > Tested-by: John Stultz <john.stultz@xxxxxxxxxx>
> > Tested-by: Vinod Koul <vkoul@xxxxxxxxxx>
> > Signed-off-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx>
> > ---
> > 
> > Changes since v1:
> > - Picked up tested-by
> > 
> >  drivers/iommu/arm-smmu-qcom.c | 21 +++++++++++++++++++++
> >  drivers/iommu/arm-smmu.c      | 14 ++++++++++++--
> >  drivers/iommu/arm-smmu.h      |  3 +++
> >  3 files changed, 36 insertions(+), 2 deletions(-)
> 
> [...]
> 
> > diff --git a/drivers/iommu/arm-smmu.c b/drivers/iommu/arm-smmu.c
> > index fb85e716ae9a..5d5fe6741ed4 100644
> > --- a/drivers/iommu/arm-smmu.c
> > +++ b/drivers/iommu/arm-smmu.c
> > @@ -654,7 +654,9 @@ static void arm_smmu_write_context_bank(struct arm_smmu_device *smmu, int idx)
> >  
> >  	/* SCTLR */
> >  	reg = ARM_SMMU_SCTLR_CFIE | ARM_SMMU_SCTLR_CFRE | ARM_SMMU_SCTLR_AFE |
> > -	      ARM_SMMU_SCTLR_TRE | ARM_SMMU_SCTLR_M;
> > +	      ARM_SMMU_SCTLR_TRE;
> > +	if (cfg->m)
> > +		reg |= ARM_SMMU_SCTLR_M;
> >  	if (stage1)
> >  		reg |= ARM_SMMU_SCTLR_S1_ASIDPNE;
> >  	if (IS_ENABLED(CONFIG_CPU_BIG_ENDIAN))
> > @@ -678,7 +680,11 @@ static int arm_smmu_init_domain_context(struct iommu_domain *domain,
> >  	if (smmu_domain->smmu)
> >  		goto out_unlock;
> >  
> > -	if (domain->type == IOMMU_DOMAIN_IDENTITY) {
> > +	/*
> > +	 * Nothing to do for IDENTITY domains,unless disabled context banks are
> > +	 * used to emulate bypass mappings on Qualcomm platforms.
> > +	 */
> > +	if (domain->type == IOMMU_DOMAIN_IDENTITY && !smmu->qcom_bypass_quirk) {
> 
> Given that the other thread [1] with Jordan (why haven't you cc'd him?! --
> adding him now) has identified the need for a callback to allocate the
> context bank, why don't we use the same sort of idea here? If the impl
> provides a CB allocator function, call it irrespective of the domain type.
> If it allocates a domain even for an identity domain, then we can install
> if with SCTLR.M clear.

Here is what I have so far for the context bank allocator.  I think its a good
start, but it still feels a bit half baked, so comments definitely welcome.

https://lists.linuxfoundation.org/pipermail/iommu/2020-July/046754.html
https://lists.linuxfoundation.org/pipermail/iommu/2020-July/046752.html

> Will
> 
> [1] https://lore.kernel.org/r/20200716151625.GA14526@xxxxxxxxxxxxxxxxxxxxxxxxx

-- 
The Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux