Re: [RFC PATCH] interconnect: qcom: add functions to query addr/cmds for a path

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 7/1/20 07:25, Jonathan Marek wrote:
> The a6xx GMU can vote for ddr and cnoc bandwidth, but it needs to be able
> to query the interconnect driver for bcm addresses and commands.

It's not very clear to me how the GMU firmware would be dealing with this? Does
anyone have an idea whether the GMU makes any bandwidth decisions? Or is it just
a static configuration and it just enables/disables a TCS?

I think that we can query the address from the cmd-db, but we have to know the
bcm names and the path. All the BCM/TCS information looks to be very low-level
and implementation specific, so exposing it through an API is not very good,
but hard-coding all this information is not good either.

Thanks,
Georgi

> 
> I'm not sure what is the best way to go about implementing this, this is
> what I came up with.
> 
> I included a quick example of how this can be used by the a6xx driver to
> fill out the GMU bw_table (two ddr bandwidth levels in this example, note
> this would be using the frequency table in dts and not hardcoded values).
> 
> Signed-off-by: Jonathan Marek <jonathan@xxxxxxxx>
> ---
>  drivers/gpu/drm/msm/adreno/a6xx_hfi.c | 20 ++++-------
>  drivers/interconnect/qcom/icc-rpmh.c  | 50 +++++++++++++++++++++++++++
>  include/soc/qcom/icc.h                | 11 ++++++
>  3 files changed, 68 insertions(+), 13 deletions(-)



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux