The WiFi supplies that were added recently can't have done anything
useful because they were missing the "-supply" suffix. Booting
without the "-supply" suffix would give these messages:
ath10k_snoc 18800000.wifi: 18800000.wifi supply vdd-0.8-cx-mx not found, using dummy regulator
ath10k_snoc 18800000.wifi: 18800000.wifi supply vdd-1.8-xo not found, using dummy regulator
ath10k_snoc 18800000.wifi: 18800000.wifi supply vdd-1.3-rfa not found, using dummy regulator
ath10k_snoc 18800000.wifi: 18800000.wifi supply vdd-3.3-ch0 not found, using dummy regulator
Let's add the "-supply" suffix.
Fixes: 1e7594a38f37 ("arm64: dts: qcom: sc7180: Add WCN3990 WLAN module device node")
Signed-off-by: Douglas Anderson <dianders@xxxxxxxxxxxx>
---
I don't have an IDP setup but I have a similar board. Testing on IDP
would, of course, be appreciated.
Repost because I screwed up the "after-the-cut" notes on first post.
arch/arm64/boot/dts/qcom/sc7180-idp.dts | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/sc7180-idp.dts b/arch/arm64/boot/dts/qcom/sc7180-idp.dts
index 39dbfc89689e..472f7f41cc93 100644
--- a/arch/arm64/boot/dts/qcom/sc7180-idp.dts
+++ b/arch/arm64/boot/dts/qcom/sc7180-idp.dts
@@ -391,10 +391,10 @@ video-firmware {
&wifi {
status = "okay";
- vdd-0.8-cx-mx = <&vreg_l9a_0p6>;
- vdd-1.8-xo = <&vreg_l1c_1p8>;
- vdd-1.3-rfa = <&vreg_l2c_1p3>;
- vdd-3.3-ch0 = <&vreg_l10c_3p3>;
+ vdd-0.8-cx-mx-supply = <&vreg_l9a_0p6>;
+ vdd-1.8-xo-supply = <&vreg_l1c_1p8>;
+ vdd-1.3-rfa-supply = <&vreg_l2c_1p3>;
+ vdd-3.3-ch0-supply = <&vreg_l10c_3p3>;
wifi-firmware {
iommus = <&apps_smmu 0xc2 0x1>;
};
--
2.27.0.212.ge8ba1cc988-goog
