Hi Rob,
On 5/15/2020 8:31 AM, Rob Herring wrote:
On Thu, May 07, 2020 at 08:30:47PM +0530, Akash Asthana wrote:
Add documentation to support RX-TX & CTS-RTS GPIO pin swap in HW.
Signed-off-by: Akash Asthana <akashast@xxxxxxxxxxxxxx>
---
Documentation/devicetree/bindings/serial/serial.yaml | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/Documentation/devicetree/bindings/serial/serial.yaml b/Documentation/devicetree/bindings/serial/serial.yaml
index 53204d9..e657dd6 100644
--- a/Documentation/devicetree/bindings/serial/serial.yaml
+++ b/Documentation/devicetree/bindings/serial/serial.yaml
@@ -67,6 +67,12 @@ properties:
(wired and enabled by pinmux configuration). This depends on both the
UART hardware and the board wiring.
+ rx-tx-swap:
+ description: RX and TX pins are swapped.
+
+ cts-rts-swap:
+ description: CTS and RTS pins are swapped.
Need 'type: boolean' on both of these.
okay, will correct in next version
Regards,
Akash
+
if:
required:
- uart-has-rtscts
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,\na Linux Foundation Collaborative Project
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,\na Linux Foundation Collaborative Project
