Re: [PATCH v5 6/7] misc: bcm-vk: add Broadcom VK driver

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Luis,

On 2020-05-12 5:38 p.m., Luis Chamberlain wrote:
On Thu, May 07, 2020 at 05:27:38PM -0700, Scott Branden wrote:
+#if defined(CONFIG_REQ_FW_INTO_BUF_PRIV)
+
+#define KERNEL_PREAD_FLAG_PART	0x0001 /* Allow reading part of file */
+#define REQUEST_FIRMWARE_INTO_BUF request_firmware_into_buf_priv
+int request_firmware_into_buf_priv(const struct firmware **firmware_p,
+				   const char *name, struct device *device,
+				   void *buf, size_t size,
+				   size_t offset, unsigned int pread_flags);
+
+#else
+
+#define REQUEST_FIRMWARE_INTO_BUF request_firmware_into_buf
+
+#endif
+
+#endif
Please clean this up, the code must reflect only the code upstream. No
config stuff like this should be used on the driver. I had to stop my
review here.
The CONFIG_ prefix shouldn't have been there as there is no Kconfig option to select this. Would like to just change it to a normal define without CONFIG_ prefix instead? This code is here to allow a limited version of the driver to run on older kernels which do not have the necessary partial file read support. By having it in the upstream codebase we don't need to maintain an internal version of the driver.  User can take the upstream kernel module and compile it against an old version of the kernel by via the define.
   Luis
Regards,
Scott



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux