Certain platforms require different settings in the SDCC_HC_REG_DLL_CONFIG register. This setting can change from platform to platform. So the driver should check whether a particular platform require a different setting by reading the DT file and use it. Also use msm_cm_dll_set_freq only when DLL not supplied. Signed-off-by: Bao D. Nguyen <nguyenb@xxxxxxxxxxxxxx> Signed-off-by: Sarthak Garg <sartgarg@xxxxxxxxxxxxxx> --- drivers/mmc/host/sdhci-msm.c | 13 +++++++++++-- 1 file changed, 11 insertions(+), 2 deletions(-) diff --git a/drivers/mmc/host/sdhci-msm.c b/drivers/mmc/host/sdhci-msm.c index b879806..598880a 100644 --- a/drivers/mmc/host/sdhci-msm.c +++ b/drivers/mmc/host/sdhci-msm.c @@ -275,6 +275,7 @@ struct sdhci_msm_host { u32 transfer_mode; bool updated_ddr_cfg; bool uses_tassadar_dll; + u32 dll_config; u32 ddr_config; }; @@ -617,6 +618,9 @@ static int msm_init_cm_dll(struct sdhci_host *host) config &= ~CORE_CLK_PWRSAVE; writel_relaxed(config, host->ioaddr + msm_offset->core_vendor_spec); + config = msm_host->dll_config; + writel_relaxed(config, host->ioaddr + msm_offset->core_dll_config); + if (msm_host->use_14lpp_dll_reset) { config = readl_relaxed(host->ioaddr + msm_offset->core_dll_config); @@ -642,7 +646,9 @@ static int msm_init_cm_dll(struct sdhci_host *host) config |= CORE_DLL_PDN; writel_relaxed(config, host->ioaddr + msm_offset->core_dll_config); - msm_cm_dll_set_freq(host); + + if (!msm_host->dll_config) + msm_cm_dll_set_freq(host); if (msm_host->use_14lpp_dll_reset && !IS_ERR_OR_NULL(msm_host->xo_clk)) { @@ -682,7 +688,8 @@ static int msm_init_cm_dll(struct sdhci_host *host) msm_offset->core_dll_config); if (msm_host->use_14lpp_dll_reset) { - msm_cm_dll_set_freq(host); + if (!msm_host->dll_config) + msm_cm_dll_set_freq(host); config = readl_relaxed(host->ioaddr + msm_offset->core_dll_config_2); config &= ~CORE_DLL_CLOCK_DISABLE; @@ -1944,6 +1951,8 @@ static inline void sdhci_msm_get_of_property(struct platform_device *pdev, if (of_property_read_u32(node, "qcom,ddr-config", &msm_host->ddr_config)) msm_host->ddr_config = DDR_CONFIG_POR_VAL; + + of_property_read_u32(node, "qcom,dll-config", &msm_host->dll_config); } -- 2.7.4