[PATCH V1 3/7] mmc: sdhci-msm: Update dll_config_3 as per HSR

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Update dll_config_3 as per the host clock frequency as specified in the
DLL Hardware Reference Guide.

Signed-off-by: Sarthak Garg <sartgarg@xxxxxxxxxxxxxx>
---
 drivers/mmc/host/sdhci-msm.c | 13 +++++++++++++
 1 file changed, 13 insertions(+)

diff --git a/drivers/mmc/host/sdhci-msm.c b/drivers/mmc/host/sdhci-msm.c
index dad008e..0f7baaf 100644
--- a/drivers/mmc/host/sdhci-msm.c
+++ b/drivers/mmc/host/sdhci-msm.c
@@ -62,6 +62,9 @@
 #define FINE_TUNE_MODE_EN	BIT(27)
 #define BIAS_OK_SIGNAL		BIT(29)
 
+#define DLL_CONFIG_3_LOW_FREQ_VAL	0x08
+#define DLL_CONFIG_3_HIGH_FREQ_VAL	0x10
+
 #define CORE_VENDOR_SPEC_POR_VAL 0xa9c
 #define CORE_CLK_PWRSAVE	BIT(1)
 #define CORE_HC_MCLK_SEL_DFLT	(2 << 8)
@@ -695,6 +698,16 @@ static int msm_init_cm_dll(struct sdhci_host *host)
 			ENABLE_DLL_LOCK_STATUS | BIAS_OK_SIGNAL;
 		writel_relaxed(config, host->ioaddr +
 				msm_offset->core_dll_usr_ctl);
+
+		config = readl_relaxed(host->ioaddr +
+				msm_offset->core_dll_config_3);
+		config &= ~0xFF;
+		if (msm_host->clk_rate < 150000000)
+			config |= DLL_CONFIG_3_LOW_FREQ_VAL;
+		else
+			config |= DLL_CONFIG_3_HIGH_FREQ_VAL;
+		writel_relaxed(config, host->ioaddr +
+			msm_offset->core_dll_config_3);
 	}
 
 	config = readl_relaxed(host->ioaddr +
-- 
2.7.4




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux