Re: [PATCH v5 3/5] thermal: devfreq_cooling: Use PM QoS to set frequency limits

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 03/04/2020 19:18, Matthias Kaehlcke wrote:
> Hi Daniel,
> 
> On Fri, Apr 03, 2020 at 06:43:20PM +0200, Daniel Lezcano wrote:
>> On 18/03/2020 12:45, Lukasz Luba wrote:
>>> From: Matthias Kaehlcke <mka@xxxxxxxxxxxx>
>>>
>>> Now that devfreq supports limiting the frequency range of a device
>>> through PM QoS make use of it instead of disabling OPPs that should
>>> not be used.
>>>
>>> The switch from disabling OPPs to PM QoS introduces a subtle behavioral
>>> change in case of conflicting requests (min > max): PM QoS gives
>>> precedence to the MIN_FREQUENCY request, while higher OPPs disabled
>>> with dev_pm_opp_disable() would override MIN_FREQUENCY.
>>>
>>> Signed-off-by: Matthias Kaehlcke <mka@xxxxxxxxxxxx>
>>> Reviewed-by: Lukasz Luba <lukasz.luba@xxxxxxx>
>>> Reviewed-by: Chanwoo Choi <cw00.choi@xxxxxxxxxxx>
>>
>> This patch is standalone, right? If yes, I will apply it.
> 
> Yes, it is standalone, please apply

Applied on 'testing', thanks


-- 
<http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs

Follow Linaro:  <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux