Hi all, Here is a series splitting up the thermal bindings into 3 separate bindings in YAML, one each of the sensor, cooling-device and the thermal zones. A series to remove thermal.txt and change over all references to it will follow shortly. Another series to fixup problems found by enforcing this yaml definition across dts files will also follow. Changes since v3: - Clarify example by using cooling state numbers and a comment - Restrict thermal-sensors to a single reference to reflect actual code where there is a one-to-one mapping between sensors and thermal zones - Add two optional properties that were missed in earlier submissions: coefficients and sustainable-power - Improve description of hysteresis and contribution properties - Added Acks. Changes since v2: - Addressed review comment from Rob - Added required properties for thermal-zones node - Added select: true to thermal-cooling-devices.yaml - Fixed up example to pass dt_binding_check Changes since v1: - Addressed review comments from Rob - Moved the license back to GPLv2, waiting for other authors to give permission to relicense to BSD-2-Clause as well - Fixed up warnings thrown by dt_binding_check I have to add that the bindings as they exist today, don't really follow the "describe the hardware" model of devicetree. e.g. the entire thermal-zone binding is a software abstraction to tie arbitrary, board-specific trip points to cooling strategies. This doesn't fit well into the model where the same SoC in two different form-factor devices e.g. mobile and laptop, will have fairly different thermal profiles and might benefit from different trip points and mitigation heuristics. I've started some experiments with moving the thermal zone data to a board-specific platform data that is used to initialise a "thermal zone driver". In any case, if we ever move down that path, it'll probably end up being v2 of the binding, so this series is still relevant. Regards, Amit Amit Kucheria (3): dt-bindings: thermal: Add yaml bindings for thermal sensors dt-bindings: thermal: Add yaml bindings for thermal cooling-devices dt-bindings: thermal: Add yaml bindings for thermal zones .../thermal/thermal-cooling-devices.yaml | 116 ++++++ .../bindings/thermal/thermal-sensor.yaml | 72 ++++ .../bindings/thermal/thermal-zones.yaml | 341 ++++++++++++++++++ 3 files changed, 529 insertions(+) create mode 100644 Documentation/devicetree/bindings/thermal/thermal-cooling-devices.yaml create mode 100644 Documentation/devicetree/bindings/thermal/thermal-sensor.yaml create mode 100644 Documentation/devicetree/bindings/thermal/thermal-zones.yaml -- 2.20.1
