Changes in v3: - Add pm events notification to check if suspend started - Add cpu pm notification to enable wake IRQs during deep/s2idle suspend - Add pdc_pm_data structure as domain->host_data and as irq's chip_data - Add changes to mark wakeup and enabled IRQs in respective domains - Address Stephen's comments from v2. Changes in v2: - Drop pinctrl irqchip change and update in PDC irqchip change - Include more details for .irq_set_wake introduction - Address Stephen's comments for CPUidle need not call enable_irq_wake - Update cover letter inline to add more detail on problem and solution irqchip: qcom: pdc: Introduce irq_set_wake call Some drivers using gpio interrupts want to configure gpio for wakeup using enable_irq_wake() but during suspend entry disables irq and expects system to resume when interrupt occurs. In the driver resume call interrupt is re-enabled and removes wakeup capability using disable_irq_wake() one such example is cros ec driver. With [1] in documentation saying "An irq can be disabled with disable_irq() and still wake the system as long as the irq has wake enabled". In such scenario the gpio irq stays disabled at gpio irqchip but needs to keep enabled in the hierarchy for wakeup capable parent PDC and GIC irqchip to be able to detect and forward wake capable interrupt to CPU when system is in sleep state like suspend. The final status at PDC irq_chip should be an "OR" of "enable" and "wake" calls. (i.e. same per below table) |--------------------------------------------------| | ENABLE in SW | WAKE in SW | PDC & GIC HW Status | | 0 | 0 | 0 | | 0 | 1 | 1 | | 1 | 0 | 1 | | 1 | 1 | 1 | |--------------------------------------------------| Sending this as an RFC since this series attempts to add support for [1] by introducing irq_set_wake call for PDC irqchip from which interrupt can be enabled/disabled at PDC (and its parent GIC) hardware. Note that *ALL* drivers using wakeup capable interrupt with enable_irq_wake() and want to disable irq with disable_irq() need to call disable_irq_wake() also if they want to stop wakeup capability at parent PDC irqchip. Not doing so will lead to system getting woken up from sleep states if wakeup capable IRQ comes in. [1] https://www.spinics.net/lists/kernel/msg3398294.html Maulik Shah (1): irqchip: qcom: pdc: Introduce irq_set_wake call drivers/irqchip/qcom-pdc.c | 271 ++++++++++++++++++++++++++++++++++++++++++--- 1 file changed, 256 insertions(+), 15 deletions(-) -- QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, hosted by The Linux Foundation