We don't currently call put_device in case of successfully initialising the device. So we hold the reference and keep the device pinned forever. Allow control to fall through so we can use same code for success and error paths to put_device. As a part of this fixup, change devm_ioremap_resource to act on the same device pointer as that used to allocate regmap memory. That ensures that we are free to release op->dev after examining its resources. Signed-off-by: Amit Kucheria <amit.kucheria@xxxxxxxxxx> Reviewed-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx> Link: https://lore.kernel.org/r/9fa8a4e09b6fcff4b9d4facc9f9e9f8e3c4a41d5.1582048155.git.amit.kucheria@xxxxxxxxxx --- drivers/thermal/qcom/tsens-common.c | 6 ++---- 1 file changed, 2 insertions(+), 4 deletions(-) diff --git a/drivers/thermal/qcom/tsens-common.c b/drivers/thermal/qcom/tsens-common.c index 1cbc5a6e5b4f..013750fff8b2 100644 --- a/drivers/thermal/qcom/tsens-common.c +++ b/drivers/thermal/qcom/tsens-common.c @@ -602,7 +602,7 @@ int __init init_common(struct tsens_priv *priv) /* DT with separate SROT and TM address space */ priv->tm_offset = 0; res = platform_get_resource(op, IORESOURCE_MEM, 1); - srot_base = devm_ioremap_resource(&op->dev, res); + srot_base = devm_ioremap_resource(dev, res); if (IS_ERR(srot_base)) { ret = PTR_ERR(srot_base); goto err_put_device; @@ -620,7 +620,7 @@ int __init init_common(struct tsens_priv *priv) } res = platform_get_resource(op, IORESOURCE_MEM, 0); - tm_base = devm_ioremap_resource(&op->dev, res); + tm_base = devm_ioremap_resource(dev, res); if (IS_ERR(tm_base)) { ret = PTR_ERR(tm_base); goto err_put_device; @@ -687,8 +687,6 @@ int __init init_common(struct tsens_priv *priv) tsens_enable_irq(priv); tsens_debug_init(op); - return 0; - err_put_device: put_device(&op->dev); return ret; -- 2.20.1
