Hi Matthias,
On 2/19/2020 12:37 AM, Matthias Kaehlcke wrote:
Hi Akash,
I didn't see a patch that implements the binding, did you post it?
We haven't posted any update on patch@
https://patchwork.kernel.org/cover/11313817/
[tty: serial: qcom_geni_serial: Configure UART_IO_MACRO_CTRL register].
We will spin it ASAP.
On Mon, Feb 17, 2020 at 03:06:52PM +0530, Akash Asthana wrote:
Add documentation to support RX/TX/CTS/RTS pin swap in HW.
Signed-off-by: Akash Asthana <akashast@xxxxxxxxxxxxxx>
---
Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.yaml | 9 +++++++++
1 file changed, 9 insertions(+)
diff --git a/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.yaml b/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.yaml
index 11530df..7e4b9af 100644
--- a/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.yaml
+++ b/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.yaml
@@ -165,6 +165,15 @@ patternProperties:
- description: UART core irq
- description: Wakeup irq (RX GPIO)
+ rx-tx-swap:
+ description: RX and TX pins are swap.
s/swap/swapped/
Ok
+
+ cts-rts-swap:
+ description: CTS and RTS pins are swap.
s/swap/swapped/
Ok
+
+ rx-tx-cts-rts-swap:
+ description: RX-TX and CTS-RTS both pairs are swap.
I don't think this option adds much value, if both pairs are swapped
the above two properties can be set.
Yeah ok, It is possible to derive value for rx-tx-cts-rts if above 2
properties are set.
+
required:
- compatible
- interrupts
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,\na Linux Foundation Collaborative Project
Thanks for reviewing,
Regards,
Akash
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,\na Linux Foundation Collaborative Project
