On Mon, 17 Feb 2020 15:06:50 +0530, Akash Asthana wrote: > Convert QUP geni-se bindings to DT schema format using json-schema. > > Signed-off-by: Akash Asthana <akashast@xxxxxxxxxxxxxx> > --- > Changes in V2: > - As per Stephen's comment corrected defintion of interrupts for UART node. > Any valid UART node must contain atleast 1 interrupts. > > Changes in V3: > - As per Rob's comment, added number of reg entries for reg property. > - As per Rob's comment, corrected unit address to hex. > - As per Rob's comment, created a pattern which matches everything common > to geni based I2C, SPI and UART controller and then one pattern for each. > - As per Rob's comment, restored original example. > > Changes in V4: > - Resolve below compilation error reported from bot. > > /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/soc/qcom/ > qcom,geni-se.yaml: properties:clocks:minItems: False schema does not allow 2 > /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/soc/qcom/ > qcom,geni-se.yaml: properties:clocks:maxItems: False schema does not allow 2 > Documentation/devicetree/bindings/Makefile:12: recipe for target > 'Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.example.dts' failed > make[1]: *** [Documentation/devicetree/bindings/soc/qcom/ > qcom,geni-se.example.dts] Error 1 > Makefile:1263: recipe for target 'dt_binding_check' failed > make: *** [dt_binding_check] Error 2 > > .../devicetree/bindings/soc/qcom/qcom,geni-se.txt | 94 --------- > .../devicetree/bindings/soc/qcom/qcom,geni-se.yaml | 209 +++++++++++++++++++++ > 2 files changed, 209 insertions(+), 94 deletions(-) > delete mode 100644 Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt > create mode 100644 Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.yaml > Reviewed-by: Rob Herring <robh@xxxxxxxxxx>
