On Thu 06 Feb 00:33 PST 2020, Can Guo wrote:
> After enter hibern8, as UFS JEDEC ver 3.0 requires, a specific gating wait
> time is required before disable the device reference clock. If it is not
> specified, use the old delay.
>
> Signed-off-by: Can Guo <cang@xxxxxxxxxxxxxx>
> Reviewed-by: Asutosh Das <asutoshd@xxxxxxxxxxxxxx>
> Reviewed-by: Hongwu Su <hongwus@xxxxxxxxxxxxxx>
> ---
> drivers/scsi/ufs/ufs-qcom.c | 22 +++++++++++++++++++---
> 1 file changed, 19 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/scsi/ufs/ufs-qcom.c b/drivers/scsi/ufs/ufs-qcom.c
> index 85d7c17..39eefa4 100644
> --- a/drivers/scsi/ufs/ufs-qcom.c
> +++ b/drivers/scsi/ufs/ufs-qcom.c
> @@ -833,6 +833,8 @@ static int ufs_qcom_bus_register(struct ufs_qcom_host *host)
>
> static void ufs_qcom_dev_ref_clk_ctrl(struct ufs_qcom_host *host, bool enable)
> {
> + unsigned long gating_wait;
> +
> if (host->dev_ref_clk_ctrl_mmio &&
> (enable ^ host->is_dev_ref_clk_enabled)) {
> u32 temp = readl_relaxed(host->dev_ref_clk_ctrl_mmio);
> @@ -845,11 +847,25 @@ static void ufs_qcom_dev_ref_clk_ctrl(struct ufs_qcom_host *host, bool enable)
> /*
> * If we are here to disable this clock it might be immediately
> * after entering into hibern8 in which case we need to make
> - * sure that device ref_clk is active at least 1us after the
> + * sure that device ref_clk is active for specific time after
> * hibern8 enter.
> */
> - if (!enable)
> - udelay(1);
> + if (!enable) {
> + gating_wait = host->hba->dev_info.clk_gating_wait_us;
> + if (!gating_wait) {
Afaict this can't happen, because in patch 6 you check for gating_wait
being 0 and if so set it to 0xff.
> + udelay(1);
> + } else {
> + /*
> + * bRefClkGatingWaitTime defines the minimum
> + * time for which the reference clock is
> + * required by device during transition from
> + * HS-MODE to LS-MODE or HIBERN8 state. Give it
> + * more time to be on the safe side.
> + */
> + gating_wait += 10;
> + usleep_range(gating_wait, gating_wait + 10);
I presume there's no strong requirement on the max, so how about using a
substantially larger max - say 1k, or 10k - to allow the usleep_range()
to do it's job?
PS. Please include linux-arm-msm@ on all the patches in the series, not
just two of them.
Regards,
Bjorn
> + }
> + }
>
> writel_relaxed(temp, host->dev_ref_clk_ctrl_mmio);
>
> --
> The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
> a Linux Foundation Collaborative Project
